GT Products 5092 is a room temperature curing silicone rubber compound designed for the manufacture of flexible molds.
GT Products©5092 features:
GT Products 5092 is supplied in matched kits with Catalyst 5092 designed to be used in a
10:1 ratio by weight.
Because pigments can settle during storage, Catalyst 5092 should be thoroughly stirred before mixing. Use separate tools for mixing the base and catalyst to avoid cross contamination. Low-shear mixing of the mixture is recommended. Add the catalyst to the base and mix until the color is uniform. Use clean tools and scrape the bottom and sides of the container to assure a homogeneous mixture. Avoid stirring in an excessive amount of air.
Base Catalyst
Color white Purple Specific Gravity 1.12 0.98 Viscosity (cPs) 70,000 100 Mixed Viscosity 31000 Pot Life (pour time) 60-90 min.
After cure (7 days @ 25°C)
Tensile, psi: 600 Elongation, % 500 Durometer, Shore A 20 Tear(die B) minimum 150 Linear shrinkage;%: 0.3-0.4 Specific Gravity: 1.1
Air entrapped during mixing should be removed to prevent voids in the cured product. Deair the mixed material under a vacuum of 25 mm (29 inches) of mercury. The mixture will froth and, expand four times its volume, crest and recede to about the original level as the bubbles break. Degassing is usually complete about two minutes after frothing subsides.
GT Products 5092 will cure sufficiently in 16 hours at room temperature (72°F) to be handled. GT 5092 will reach 90% of ultimate cure in 24 hours at room temperature. For full cure an additional 1-2 days at room temperature is required.
GT Products 5092 will remain useful for six months when stored in the original unopened containers at temperatures below 80°F (27°C). Both GT Products 5092 and catalyst-5092 are sensitive to moisture. Keep containers covered.
GT Products 5092 is a condensation (“Tin catalyst”) cure system. It will cure in contact with most clean dry surfaces. GT Products 5092 will cure in contact with materials such as butyl and chlorinated rubbers, sulfur-containing materials, amines and other condensation RTV silicones which would inhibit the cure of addition-cure RTV rubber.
The above information is based on typical experience and should not be used for specification writing. Suitability of this product for a specific application should be determined under actual use conditions. No warranty, either expressed or implied, is hereby made.
June 2006